Phoenix Model

Funstar 3D Mk2 .46-.55 GP/EP ARF 58.8 PH119

Phoenix Model


This is the Radio Controlled, Glow or Electric Powered,

Almost Ready to Fly 1.6 scale Funstar Mk2 3D Airplane from Phoenix Models.

For Pilots with Intermediate Level of Experience.


Construction: Lightweight laser cut wood
Wing: One-piece
Aileron Control: Dual servo
Covering: High quality heat shrink covering
Cowl: Factory painted hand laid fiberglass
Spinner: Red plastic, 2.3" (58mm) diameter
Canopy: Clear molded plastic with painted pilot figure
Landing Gear: Prebent aluminum with 2.5" (63.5mm) main wheels, 1"
(25.4mm) rubber tailwheel
Fuel Tank: Approximately 10oz (300cc)
Wheel Pants: Factory painted hand laid fiberglass
Engine Mount: Two-piece composite
Motor Mount: Plywood
Building Time: Ready to fly in several hours


ARF Funstar Mk2 3D Airplane with Spinner, Pilot Figure. Landing Gear
Fuel Tank, and Instruction Manual


Radio: At least 4 channel with 4 mini high torque, one throttle servo
if using glow engine
Receiver Battery: 800-1200mAh NiMH
Glow Power-
Engine: 2-stroke .46-.55 cu in OR 4-stroke .52 cu in
Propeller: to match selected engine
Fuel, glow starter, throttle servo
Electric Power-
Brushless Motor: 1000-1400kV outrunner
ESC: To match selected motor
LiPo Battery: 3-6S
Battery Charger: To match selected battery
Propeller: To match selected motor
Building and field equipment


Wingspan: 58.8" (1495mm)
Length: 55.3" (1405mm)
Weight: 74-81oz (2.1-2.3kg)
Wing Area: 914 sq in (59 sq dm)
Wing Loading: 12.8 oz sq/in (39 g sq/dm)
Center of Gravity (CG): 4.7-4.9" (120-125mm) back from leading edge
of wing measured at the fuselage
Control Throws-
Ailerons (up & down): 0.47" (12mm), 10% expo
Rudder (right & left): 0.98" (25mm), 15% expo
Elevator (up & down): 0.47" (12mm), 12% expo